Fix Power Window Motor

In most applications the bolts securing the motor to the door are the same size as the regulator mounting bolts.

Fix power window motor.

In order to fix a power window motor a trained technician will need to replace all faulty components by unbolting the broken parts and replacing them with new ones. It is very easy any one can do it with simple tools if you liked this video please. Attach the multimeter to the wires then activate the window switch with the car s key in the on position. Experienced technicians can complete most power window repairs in one hour or less.

Locate and remove the window motor mounting bolts. Start the auto window repair by removing all the trim panel fasteners to access the switch for testing. Connect the leads of your voltmeter to the two terminals on the connector. The power window service does not usually take a lot of time once technicians track down the main problem.

Hold your window switch in the up position. In many cases the power window repair process simply entails total replacement of the faulty components. Check for operation of the window with the engine on and off and with the key in different positions. A trim panel removal tool is inexpensive and saves you a lot of time.

Locate the power window motor it s usually located near the bottom on the affected car door. How long does it take to fix a power window. Technicians unbolt the old components and hook up a direct replacement to restore full functionality of your windows. The power window motor is much smaller than the regulator but should be located close by.

Replace the motor by pressing it into the window regulator gears then securing the mount bolts and reconnecting it to the harness. This is a window motor from a 94 s10 blazer. When you put power to it the motor will turn about an 1 8 of an inch then nothing both ways. Remove them and set them someplace safe as well.

Car power window repairs. Repair your defunct car power window free at cost at home and save money. Then using your fist or a blunt object strike a spot in the general area where the power window motor is located. So i thought it was.

Remove the trim panel and peel off the vapor barrier. If you are getting power in both directions of the switch then the electrical wiring to the motor is good and the motor should be replaced. If you re unsure where it is you may be able to look it up online. If you are not getting power to the motor wiring then you need to check for power going to the window switch.