Carefully slide the notched piece of siding into place.
First course of bevel siding.
Siding should be nailed to each stud or on 16 inch centers.
Installing bevel siding clapboards spacing for the siding should be laid out beforehand.
For bevel siding this is a minimum of 1 inch.
Click here to read a short course on cladding part 2.
The rabetted bevel dolly varden pattern features a 1 2 3 4 notch in the thicker butt end of the board this rabbeted edge cut allows the bevel siding panels to fit together in such a way as to protect joints from water infiltration.
Place the nail just above the overlap.
One edge has a thick butt while the other edge is thinner.
Each succeeding course overlaps the upper edge of the lower course.
Set the first bevel board in place against the trim at a corner of the house.
It is lumber that has been resawn at an angle resulting in two pieces.
The number of board spaces between the soffit and bottom of the lowest piece of siding at the foundation should be such that the overlap is as per the table.
It is normally blocked out with a starting strip the same thickness as the top of the siding board see figure a.
Siding may be installed starting with the bottom course.
Bevel wood siding provides rustic warmth for homes and log cabins.
Align the bottom of the bevel plank with the bottom of the starter strip with the end flush against the trim and.
The dolly varden rabbeted bevel profile is an easier install while providing the same traditional bevel style and appearance.
Bevel siding also referred to as clapboard siding is a very popular wood siding product.
Make sure the first course is level.
This is the first of a 2 part series.
Clapboards have a triangular cut.
Western red cedar bevel siding is the most widely used siding type.
Join the clapboards with scarf joints as in step 3.
If more than one clapboard is needed to span a wall snap a chalk line between the marks on the corner boards on top of the course being overlapped.
Nail the clapboard to the studs.
The most familiar type of wood siding is the clapboard a form of lap siding that s also called bevel siding.
With dolly varden siding you get the appearance of bevel and clapboard siding but the convenience of self spacing thanks to the rabbet at the bottom to accept the top of the preceding course.
Start with the bottom course using a furring strip to support the lower edge.
Each succeeding course overlaps the one below.
It is produced by resaying lumber at an angle to produce two pieces thicker on one edge than the other.
They are lapped to shed water.
On rabbeted bevel siding leave a 1 8 inch expansion clearance.
Thinner at the top and wider near the lower more exposed part of the board.
The manufacturing process results in pieces with one face saw textured.
